Guide to BioX AAL-band 2.0
Using the new Wearable Technology, BioX AAL-Band you are able to control your device with a wave, using new patterned gesture sensing technology.
1. Wear the AAL-band on the forearm near elbow joint.
2. Press the ‘ON’, to turn on or restart the AAL-band.
3. Green and Red led will blink twice with two seconds gap. After that RED.
Green LED will blink with 2 second gap during data transmission from
When the AAL-band is taken off shut down is initiated automatically after 20 seconds.
Shut down can also be initiated by pressing ‘OFF’ button.
During shut down the RED led will blink five times with one second gap
BioX AAL-band is capable of functioning reliably in industrial environments. By using FMG Atechnology and IMU sensors, the Biox AAl-Band achieves detect the accuracy of over 90%.
Ultra-Low Power Consumption
BioX AAL-band achieves ultra-low power consumption with state-of-the-art features, such as various power modes and dynamic power scaling.
BioX AAL-band is highly-integrated with FMG sensors, IMU, Blue tooth, low-noise receive amplifier, and power management modules.
BioX AAL-band is constructed using a soft material, which is comfortable to wear and works without fatigue for long period.
NOTICE! The AAL-Band is to be used for the forearm with a circumference between 22cm and 25cm.
Micro-USB and Bluetooth
An array of eight FSR sensors to measure the muscle contraction intensity. Highly sensitive IMU to measure angular velocity, linear acceleration, and orientation of the limb. Tri-axis gravity forces can also be measured.
Rechargeable lithium battery.
Approximately four hours of use in a full single charge.
Micro-USB charging. Input voltage – 5V.
Xtensa® single-/dual-core 32-bit LX6 microprocessor.